Ecolink Z-Wave Motion Sensor PIR-ZWAVE2.5-ECO
The PIRZWAVE2.5-ECO is a battery-powered motion sensor for home security or home automation applications
Features
Advanced Sensing
Senses the presence of motion within a room (pet immunity up to 85 lbs.) and sends notifications to your security system or home automation platform.
Tamper Detection
Notifies your system when someone tampers with the sensor.
Wireless Operation
Battery powered Z-Wave network operation enables installation flexibility.
Setup
Connected Home Setup
Setup Instructions
Start by placing the system controller into inclusion mode.
Activate inclusion mode for the sensor by removing the plastic pull-tab from the back of the sensor or inserting the battery.
When the inclusion process is complete the red LED will turn on for approximately 10 seconds and then it will go out. If the LED continues to flash repeat the inclusion process.
Test the sensor. Place the sensor in an unoccupied room.
Leave the room for at least 4 minutes.
Return to the room and pass in front of the sensor lens.
The LED will flash once to indicate that motion was detected.
First attach the sensor mounting bracket to the wall using either adhesive tape OR screws (optional).
For best performance mount the bracket 6.5 to 7.5 feet above the floor (2 to 2.3 meters).
Once the mounting bracket is in place, align the holes on the back of the motion detector with the key on the bracket.
Slide the sensor down on the keys until it snaps tight.
The motion sensor has sensitivity adjustment via jumper placement on a pair of pins on the circuit board of the sensor.
Refer to the battery replacement section to open the case and find the jumper pins inside the case.
FAQ
Frequently Asked Questions
The sensor pacakge includes:
1 x PIRZWAVE2.5-ECO Sensor
1 x Mounting bracket
1 x Jumper
4 x Mounting Screws
1 x CR123A battery
1 x Installation Manual
3 x Mounting Adhesive
The distribution pattern of the motion detector is approximately +/- 50 degrees left and right of center and at maximum sensitivity will reach a maximum of approximately 45 feet.
The sensor uses 1 CR123A battery.
The sensor is a Z-wave compliant device
The sensor implements a check-in process by which it contacts the system on a periodic basis and provides an update of its operational state.
Yes. You can have multiple sensors operating on the same network/system. Please consult with your system provider to deteremine if there is a limit on the total number of devices that can be associated with your system.
You can find self-help articles at the following site: https://discoverecolink.com/support/. Alternatively, you can request support via email by writing to [email protected]