Ecolink Zigbee 3.0 Contact Sensor DWZB1-ECO
The DWZB1-ECO is a battery-powered door/window sensor for home security or home automation applications
Features
Advanced Sensing
Keeps track of the open/closed status of your doors/window and notifies you of any changes.
Tamper Detection
Notifies your system when someone tampers with the sensor.
Wireless Operation
Battery powered Zigbee network operation enables installation flexibility.
Setup
Connected Home Setup
Setup Instructions
For best results, join the device to your system before installation.
Pull the exposed plastic tab from the sensor.
The LED indicator will be lit for two seconds to indicate a successful booting.
It will blink three times approximately every 30 seconds while scanning the network.
If network is not found after 10 minutes, the sensor will go into sleep mode. To wake the sensor again, you need to use magnet or tamper to trigger a paring process, and then sensor will repeat steps from 3 to 4.
Please make sure that the sensor and magnet is located less than 0.25 inch from each other. For optimal performance, it is highly recommended to install the Door/Window sensor on the fixed frame and the magnet on the moving part of the door/window. Place the sensor near the top of the door that close to the opening edge of the door. This is the mounting location for the sensor.
Use the provided double-sided tape on the sensor. Attach the sensor to the door/window frame. Press firmly and hold in place for a few seconds. Secure it with silicone if needed. For mounting with screws, please use the screw holes located in the battery compartment.
Use provided double-sided tape on the magnet. Make sure the alignment of both sensor and magnet is correct. The magnet aligns from the top of the sensor case. Press firmly and hold in place for a few seconds. Secure it with silicone if needed.
Spacers are used to raise the level of the magnet to be level/closer to sensor. Install spacers. The spacers are ¼” thick.
FAQ
Frequently Asked Questions
The sensor package includes:
1 x DWZB1-ECO Sensor
1 x Magnet
2 x Mounting Screws
1 x CR123A battery
1 x Installation Manual
1 x 3M double sided tape
The sensor uses 1 CR123A battery.
The sensor is a Zigbee 3.0 compliant device and can participate in any standard Zigbee 3.0 network.
The sensor implements a check-in process by which it contacts the system on a periodic basis and provides an update of its operation state.
Yes. You can have multiple sensors operating on the same network/system. Please consult with your system provider to determine if there is a limit on the total number of devices that can be associated with your system.
You can find self-help articles at the following site: https://discoverecolink.com/support/. Alternatively, you can request support via email by writing to [email protected]