How do I setup the NETTV Key on my Smart Control 5?

Please ensure the Smart Control is operating the device in question before setting up the NETTV key.
When programming, wait for your device to respond first, the remote will remember the timing.
1.Make sure your device is switched on (not on standby)
2.Hold down the NETTV key until the light blinks twice and stays lit.
3.Use the Devices key to select the device you want to use for the NETTV key macro (e.g., TV)
4.Now perform the sequence of keys exactly as you would normally do. The remote will operate your device, and the macro is recorded in real time. So if it normally takes a few seconds for your device to react this is normal.
5.Once you have finished the sequence the streaming service has started on your device.
6.Hold down the NETTV key until the light blinks twice and goes out.

Note:
If the Macro doesn’t work as expected, you can repeat the same sequence to program it. The NETTV key macro is tied to one device, remember to make sure you picked the right device mode.